Change copy settings as required.
Place the next set of originals and tap the [Additional Scan] key.
Repeat this step until all originals have been scanned.
Check the preview image in the preview screen.
Check whether or not settings produce the required results.
Tap the [Print Start] key to start copying.
When making only one set of copies, you do not need to specify the number of
copies.
When changing copy settings (Copy exposure, paper size/type etc.), tap the [Change the
settings of the original to be scanned next] key. For more information, see "Changing the
copy settings for each set of originals".
When scanning the next original without changing any settings, go to step 5.
To cancel all settings:
Tap the [CA] key.
To make two or more sets of copies:
Tap the copies display key to specify the number of copies.
You cannot set a number of copies for each set.
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
330 of 1441 3/17/2016 7:14 AM
To Next Page
