To fax thick originals or pages of a book:
will stop.
When the transmission is finished, the scanned original pages are cleared from
memory. However, when the document filing function is used, the transmitted fax is
stored.
QUICK FILE
FILE
You can also send a fax by placing originals in both the automatic document feeder
and on the document glass. Original pages are then scanned and sent in sequence.
This sending method may not be available depending on the function.
SENDING A LARGE NUMBER OF PAGES(JOB BUILD)
In the following situations, the transmission will be automatically reserved (memory
transmission)
When the line is busy or a communication error occurs and automatic resending is
enabled.
WHEN A COMMUNICATION ERROR OCCURS
The line of the machine will be busy if another fax is being sent, received, or if the
machine is in the busy state.
Another fax transmission was reserved ahead of your fax.
One of the following functions is being used for transmission.
Broadcast transmission, F-code transmission, Timer transmission, Dual
Page Scan, Book Divide, 2in1, Card Shot, Job Build, Original Count
The document glass is being used (except when the speaker is being used to dial).
To disable the Quick On Line Sending setting:
In "Setting mode", select [System Settings] → [Image Send Settings] → [Fax Settings] →
[Send Settings] → [Quick On Line Sending].
If you disable this setting, transmission will not begin until all pages have been scanned. Note
that this setting does not apply to manual transmission.
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
548 of 1441 3/17/2016 7:14 AM
To Next Page
