CHECKING THE IMAGE BEFORE PRINTING
Overview
Check the image of received data on the touch panel before printing.
This function is available when [System Settings] → [Operation Settings] → [Preview
Setting] → [Received Data Image Check Setting] is enabled
*
in "Setting mode".
* The factory default setting is disabled.
Important points when using this function
If the received fax data is not printed or deleted, the fax memory will run low, and the
machine will not be able to receive any faxes. When using this function, you should print
the received data as soon as possible without leaving it in the fax memory.
You can view the remaining fax memory capacity on the fax mode base screen.
Operation
When data is received, is shown at the top of the screen.
To perform this operation, the user must have [Access to Fax Data] permission.
Depending on the size of the received data, part of the check image on the touch panel
may not appear.
The received data list can be also shown in the job status screen that appears when you
tap the job status display.
The received data can be forwarded, deleted, or saved from the received data list.
FORWARDING RECEIVED DATA MANUALLY
SAVING RECEIVED DATA
In the System Information, select the [Event Information] tab and tap the [Check Fax
Reception Image] key
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
601 of 1441 3/17/2016 7:14 AM
To Next Page
