If you intend to use own number sending, be sure to configure this
information.
To add the number of pages to be transmitted:
In "Setting mode", select [System Settings] → [Image Send Settings] → [Fax] →
[Send Settings] → [Printing Page Number at Receiver].
Page numbers appear in the format "page number/total pages". Only the page
number is printed when "Manual Transmission" or "Quick On Line Sending" is used.
To select a sender fax number or destination:
In "Setting mode", select [System Settings] → [Image Send Settings] → [Fax
Settings] → [Send Settings] → [Sender/Destination Name Change].
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
657 of 1441 3/17/2016 7:14 AM
To Next Page
