12
PART NAMES AND FUNCTIONS
(9) Punch module*
This is used to punch holes in output.
Requires a finisher (large stacker).
(10) USB connector (A type)
Supports USB 2.0 (Hi-Speed).
This is used to connect a USB device such as USB
memory to the machine.
For the USB cable, use a shielded cable.
(11) Saddle stitch finisher
*
This can be used to staple output. The saddle stitch
function for folding and stapling output and the fold function
for folding output in half are also available. A punch module
can also be installed to punch holes in output.
(12) Finisher
(large stacker)*
This can be used to staple output.
(13) Tray 1
This holds paper.
(14) Tray 2
This holds paper.
(15) Tray 3 (when a stand/1 x 500 sheet paper drawer or a
stand/2 x 500 sheet paper drawer is installed)*
This holds paper.
(16) Tray 4 (when a stand/2 x 500 sheet paper drawer is
installed)*
This holds paper.
(17) Tray 5 (when a large capacity tray is installed)*
This holds paper.
* Peripheral device.
To Next Page
Loading...
