MX-M700N MANUAL PAPER FEED SECTION E – 7
(12) Manual feed paper length detector 1
(13) Manual feed paper length detector 2
(14) Manual tray pull-out position detector 1
(15) Manual tray pull-out position detector 2
1) Remove the multi manual paper feed tray unit.
(See "A. Multi manual paper feed tray unit")
2) Remove the multi tray 250 lower.
(See "A-(11) Manual paper width detection PWB")
3) Remove the manual tray lower.
4) Disconnect the connector, and remove the manual feed paper
length detector 1 (A) and manual feed paper length detector 2
(B).
5) Disconnect the connector, and remove the manual paper feed
tray pull-out position detector 1(A) and the manual paper feed
tray pull-out position detector 2 (B).
B. Others
1) Slide the harness holder in the direction of Y and install it. The
band must be in the range of A. Pull section B in the arrow
direction to give a slack to the harness.
2) Fold the harness with your fingers and check that the harness
keeps the folded shape along the holder when it is released.
Rib C must be separated from the harness.
AB
A
B
B
Y
X
A
Band
C
To Next Page
Loading...
