Sharp MX-M623N

SHARP
TEST SIMULATION
33
43
Fuser Setting & Adjustment
34
Web cleaning motor operation check
44
Process Control Data
1
Process control mode setting
2
Process control ID gain adjustment
4
Process control initial density setup
6
Process control correction (force)
9
Process control data display
12
DM data, patch/base data display
14
Fuser temp.& humidity output data
16
Toner control output data display
21
Half tone process control registration
22
Half tone process control patch result
24
Half tone correction data result display
25
Initial half tone correction data display
26
Half tone process control correction exec.
27
Half tone process control correction clear
28
Process control timing (On/Off) setting
29
Enable/disable half tone correction.
37
Image density (DVB) adjust setting
46
Copy & Image Density Adjustment
2
Copy density adjustment (exposure)
4
Colour scanner density adjustment
5
B/W scanner density adjustment
8
Colour scanner balance adjustment
9
SPF exposure adjustment
10
Copy density adjustment (all modes)
16
Copy density manual adjustment
19
Document scanning density adjustment.
23
Engine maximum density adjustment.
24
Engine (Copy) half tone auto adjustment.
32
Document background density adjustment
37
Image create adjustment (Image Send)
39
Fax Image send sharpness adjustment
40
Fax mode exposure adjust (All modes)
41
Fax mode exposure adjust (Normal)
42
Fax mode exposure adjust (Fine Text)
43
Fax mode exposure adjust (Super Fine)
44
Fax mode exposure adjust (Ultra Fine)
45
Fax mode exposure adjustment (600dpi)
47
JPEG compression rate setting
48
Output resolution setting (Copy mode)
51
Heavy paper mode gamma adjustment
52
Heavy paper mode gamma default set
60
Adjust automatic copy mode sharpness.
61
Area separation recognition setting
46
Copy & Image Density Adjustment
63
Copy low density adjustment
74
Printer half tone auto adjustment.
90
PDF high compression ASIC adjustment
48
Magnification & Motor Adjustment
1
Magnification ratio adjustment
5
Motor speed adjustment (Scanner & SPF)
6
Motor velocity adjustment
49
Firmware & E-Manual Upgrade
1
Firmware Upgrade Program
3
E Manual Update Program
5
Watermark update
50
Image Position Adjustment
1
Lead edge/copy position adjustment
2
Lead edge/copy position adjustment value
(Calculation method)
5
Printer lead edge adjustment (sub scan)
6
SPF Lead edge/copy position adjustment
7
SPF Lead edge/copy adjustment value
10
Print off-centre deviation adjustment.
12
Original centre deviation adjustment.
27
Image loss adjustment (Fax/Scanner)
28
Service adjustment (OC/SPF position)
51
Resist Roller Adjustment
2
Resist roller adjustment
53
Document Feeder Adjustment
6
SPF document tray size adjustment
7
SPF document tray size adjust value set
8
SPF scanning position adjustment
55
MFP Data Setting
1
Engine soft switch setting
SW10-5
Threshold detection level for F2-
68 trouble.
0 = More than 60% (default)
1 = More than 85%.
2
Scanner soft switch setting.
3
Engine soft switch setting
SW5-8
Brightness offset when closing
the OC cover
0 = Offset brightness (default)
1 = Do not offset the brightness