Sharp MX-M623N - Page 34

TEST SIMULATION
SHARP
34
55
MFP Data Setting
3
Engine soft switch setting
SW8-1
SW8-2
SW8-3
Uncontaminated scan position
search (prevents lines):-
000 = Startup & Job Completion
ON.
001 = Startup only ON.
010 = Job completion only ON.
100 = OFF (Disabled)
3
Controller soft switch setting:-
SW1-5
Auto clear function before copy
job execution:-
0 =Disabled, 1 = Enabled
SW3-6
Process mixed original size
printing for duplex mode:-
0 =Disabled, 1 = Enabled
SW3-7
HP Compatibility Mode:-
0 =Disabled, 1 = Enabled
SW4-5
Paper type simplification
selection:-
0 =Disabled, 1 = Enabled
SW4-7
Paper feed size entry:-
0 =Disabled, 1 = Enabled
SW6-1
Ethernet Speed Auto
negotiation:-
0 = Enabled, 1 = Disabled
SW6-2
Ethernet Link Speed:-
0 = 100Base TX, 1 = 10Base T
SW6-3
Ethernet Duplex Mode:-
0 = Full, 1 = Half
SW6-4
Ethernet 100/1000 Link Speed:-
0 = 100Base TX, 1 = 1000Base T
SW9-5
Maintenance notification
setting by Printer MIB:-
0 = Enabled, 1 = Disabled
SW22-4
Default display setting for direct
character input:-
0 = Soft keyboard, 1 = External
SW22-5
Display toner remaining status:-
0= Disabled, 1 = Enabled/Display
SW22-7
LCD character display font:-
0 = Standard, 1 = Bold
SW24-7
Continuous print mode for OSA
(job queuing for external
accounting):-
0 = Job Queue Disabled
1 = Job Queue Enabled
10
Set stamp text.
56
MFP Data Import & Export
1
Transfer data execute
2
Export/Import Filing Data
3
Document filing data backup
4
Job log data backup
60
Memory Operation & Test
1
SDRAM read/write test (ICU)
2
SDRAM data set
61
LSU Writing Adjustment/Test
1
LSU test (Polygon motor & BD signal)
3
LSU power auto setup
62
HDD Operation & Test
1
HDD format (FAT32)
2
HDD partial read/write check
3
HDD read/write check (all areas)
6
Smart (HDD) self diagnostics test (must be
FAT32 formatted)
7
Smart (HDD) self diagnostics error log
8
HDD format (excluding system &
operation manual area)
10
Job completion list deletion (with job log)
11
Document filing data deletion
12
Enable/disable auto format (HDD trouble)
13
HDD format (manual area only)
63
CCD Operation & Adjustment
1
Shading correction data display
2
Shading correction execution (force)
3
CCD gamma & colour correction auto
adjustment
4
SIT chart patch density list display
5
CCD gamma & colour correction reset
64
Self Test Print
2
Engine test print (B/W mode)
4
Printer self print test
5
Printer self print test (PCL)
6
Printer self pint test (PS)
7
Test print (Sim 46-16 adjustment pattern).
65
LCD Operation & Adjustment
1
LCD touch panel adjustment
2
LCD touch panel adjustment result display
5
Operation panel key input test