Sharp MX-M623N

SHARP
TEST SIMULATION
35
66
Fax Control Settings & Adjustments
1
Fax Soft SW setting
2
Country code default set (Fax)
3
Fax PWB controller memory check
4
Fax signal line check (Max level)
5
Fax signal line check (Soft SW setting)
6
Fax list print (confidential registration
7
Fax memory printout (all data)
8
Fax voice message setup
9
Fax signal line check (Soft SW setting)
10
Fax all memory clear
11
Voice signal check (line/speaker 300bps)
12
Voice signal check (line/speaker 300bps)
13
Register dial number for Sim 66-14/15/16
14
Adjust & check the time dial pulse (10bps)
15
Adjust & check the time dial pulse (20bps)
16
Adjust & check send level DTFM signal
17
DTFM signal to send to line (Max level)
18
DTFM signal to send to line (Soft Sw level)
19
Write Fax Pwb SRAM data to Flashcard
20
Write telephone book data onto HDD
21
Print various registration information
22
Set the sound volume of the handset
24
Fast memory data clear
25
Register fax number for modem dial in
26
Register external telephone numbers for
Modem dial in
29
Fax address book clear
30
Tel/LIU sensor status check
31
ON/OFF of each output port (Tel/LIU)
32
Received data check (comparison)
33
Busy Tone/CNG/CED/FNET detect signal.
34
Display time required for sending test
image data
36
Modem controller Send/Receive check.
39
Check Destination saved in Fax EEPROM
42
Rewrite PIC program installed on Fax box
43
Write program & adjustment values to PIC
installed on Fax
67
Printer Settings & Adjustments
17
Printer NVRAM clear.
24
Printer density automatic adjustment.
25
Printer half tone adjustment
31
Printer calibration data clear
33
Printer screen gamma adjustment
34
Engine (Max.) adjustment mode for
printer
70
MFP PWB SRAM data clear