Note: Excludes Part Change/Correction Information.
New service parts registration.
Printer installation under Mac OSX 10.10
Measures to prevent the noise from the DSPF drive unit and drive
transport frame.
Measures to prevent wear of fusing drive gear 30T.
Staple Unit & Staple Cartridge listing
Sharp Remote Device Manager [SRDM] v1.4
Registry growth when using an auto created printer under a Citrix or
terminal services environment.
Improvement for accurate detection of DSPF transport upper actuator to
prevent SPPD2_S paper jam.
Measures to prevent shutters from falling out.
Improvement for peeled fusing rear discharge brush
Sharp Remote Device Manager [SRDM] v1.3
Change of colour of the heater lamp connector / harness
Measures to prevent F0-10 trouble during initial operation of the staple
unit
Defective return of the upper separate pawl when clearing a paper jam
Incorrect detection of cleaning web roller web end
Upgrade to prevent damage to the upper heat roller by the separate pawl
Countermeasures to prevent toner leakage from the end of the waste
toner transfer pipe within the process unit
Measures to prevent document jams (SPPD2_S) due to insufficient
recovery of the transport upper actuator.
Service manual correction - Sim 43-01 default values
Scan to OSX10.7 using FTP
Configuring ID card with internal user control
Rom version upgrade (including revision history)
Countermeasure to reduce noise from the DSPF upper & lower transport
units
Lens unit & Scanner control PWB
Rom version upgrade (including revision history)
Measures against T1PPD_S paper jam due to paper dust contamination on
the T1PPD sensor
Sharp Remote Device Manager (SRDM) v1.1
Rom version upgrade - Support for LCD manufactured by Chimei
Keyboard recognition failure and/or freezing
Rom version upgrade (including revision history)
Sharp Remote Device Manager (SRDM)
To Next Page
Loading...
