Sharp MX-M753 - Page 738

7-36
SYSTEM SETTINGS
Contents
*1 When a saddle stitch finisher is installed.
*2 When a finisher is installed.
*3 When a large capacity tray is installed.
*4 When a saddle stitch finisher or finisher is installed.
*5 When an inserter is installed.
*6 When a punch module is installed.
Copy Function Settings
 Disabling of Finisher*
4
Disabled 7-72
 Disabling of Inserter*
5
Disabled 7-72
 Disabling of Offset Disabled 7-72
 Disabling of Stapler*
4
Disabled 7-72
 Disabling of Punch*
6
Disabled 7-72
● Fusing Control Settings 16 - 23 lbs. (60 - 89g/m
2
) 7-72
Item Factory default setting Page
■ Copy Function Settings
7-73
● Initial Status Settings
7-73
 Paper Tray Varies depending on the machine
configuration
 Exposure Type Auto
 Copy Ratio 100%
 2-Sided Copy 1-Side to 1-Side
 Output –
● Other Settings 7-74
 Copy Exposure Adjustment 5 7-74
 Rotation Copy Setting Enabled 7-74
 Add or Change Extra Preset Ratios – 7-74
 Setting a Maximum Number of Copies 999 7-74
 Initial Margin Shift Setting
7-74 Side 1 1/2"
 Side 2 1/2"
 Erase Width Adjustment
7-74 Edge Clearance Width 1/2"
 Center Clearance Width 1/2"
 Card Shot Settings
7-74 Original Size X: 3-3/8", Y: 2-1/8"
 Fit to Page Disabled
 Automatic Saddle Stitch* Enabled 7-74
 Initial Tab Copy Setting 1/2" 7-74
Item Factory default setting Page