1-55
BEFORE USING THE MACHINE
Disposal of hole punch scrap (when the punch module is installed)
5
Return the saddle stitch holder and the
saddle stitch unit to their respective
original positions.
6
Make sure that the finisher is firmly attached to the machine and that 11" x 17",
8-1/2" x 11"R, or 8-1/2" x 14" (A3, A4R, or B4) size paper is loaded.
If one of the above paper sizes is not set, test stapling cannot be performed.
7
Close the lower cover of the finisher.
Test stapling is automatically performed on a blank sheet.
This operation is carried out to avoid blank stapling.
If test stapling fails to take place, repeat steps 1 to 7.
1
Open the front cover of the finisher.
2
Holding the black handle, slide out the
case containing the paper bits, and
dispose of them properly.
3
Return the waste case to its original position.
4
Close the front cover of the finifher.
To Next Page
Loading...
