Sharp MX3050 - Clean for Void Areas; Insert Gray Wand Above Black Sticker; Run Cleaner Front to Back

Step 3: Locate black scker with green tri-
angles. Insert gray cleaning wand, foam pad
side facing down, into the hole directly
above the black scker. Carefully push gray
wand back as far as it will go (It will not go
back the enre length of the wand). Run
the cleaner front to back a few mes. Re-
peat for each color- (Y, M, C, B)
For void areas on prints and copies
follow Step 3.
• For lines on prints and copies,
skip to Step 4.