Sharp PC-E500S - Page 12

PC-E500S
2. Nut holding tape attachment reference
After inserting the nut, attach according to the reference shown
below:
Reterence Nut holding tape
3. Battery holding cushion attachment reference
; Battery holding cushion
Seribed line Scribed line
s os t - LLL AS ; ets .
1
(Reterence = os Reference >
\
Battery
cover
Attach
within
the
range
of
the
scribed
lines.
4, Buzzer attachment
@ Remove the separation sheet from the buzzer spacer, and attach
the buzzer to the spacer. 7
Buzzer spacer Buzzer
(= {NS
yc)
( | (C yy
Fit R and attach properly so that the
buzzer lead wire is in the upper side.
Pee NER R RE RT ATT
ea ecPs
Hoe
@ Attach the assembly over the HD61203 on the PWB.
Attach so that the lead wire is in the upper side.
Center
Reference ==»
Align the spacer edge.
@ Solder the lead wire and fix with tape.
Ces
6. Note for handling PWB
& Jumper wire process