Sharp PN-70SC3 - Menu Customization and Classic Menu; Icon Size Adjustment; Classic Menu Interface

ENGLISH
7
E
Turning Power On/Off
Caution
• Whenallconnectionsarecomplete,turnonthepower.
• Turnonthemonitorrstbeforeturningonthecomputeror
playbackdevice.
• EvenwhenthepoweristurnedoffwiththePOWERbutton
onthemonitor,aminuteamountofpowerisconsumedif
thepowercordisconnected.
Turning power on/off
1. Press the POWER button on the side of the monitor to
turn on the power.
ThepowerLEDlightsgreen.
Remote control sensor Power LED
Status Status of the monitor
Greenlit Poweron
Redlit Standbymode
2. Turn the power on and off with the POWER button on
the remote control.
Pointtheremotecontrolunittowardtheremotecontrol
sensoronthemonitor,andpressthePOWERbutton.
Caution
• Whenturningthepoweroffandbackon,alwayswaitforat
least5seconds.Ashortintervalmayresultinamalfunction.
• Foracompleteelectricaldisconnection,pulloutthemain
plug
n
Operation mode
Whenthemonitoristurnedonforthersttimeafterbeing
shippedfromthefactory,theoperationmodesettingscreen
willbedisplayed.SetittoMODE1orMODE2.
MODE1...OFFIFNOOPERATIONissetto4HR..(These
 settingscannotbechanged.)
Ifthereisnooperationfor4hoursormore,the
monitorautomaticallyentersstandbymode.
MODE2...Willperformstandardoperation.
OFFIFNOOPERATIONissettoDISABLE.These
settingscanbechanged.
Evenafterbeingset,changescanbemadeusing
OPERATIONMODE,locatedinthemenuofthemonitor.(See
OPERATIONMANUAL.)