Sharp PN-B401 - LAN Computer Control; Controlling Monitor via LAN Command Interface

43
E
Your monitor can be connected to a LAN allowing you to
control it from a computer on the LAN.
The connection requires a commercially available LAN cable
(UTP cable, Category 5, straight through).
Hub
Network (LAN)
LAN cable (commercially available, straight)
LAN terminal
TIPS
• Thismonitormustbeconnectedtoanetwork.
Conguresettingsrequiredforconnectiontoanetworkin
“System Setting” – “Ethernet” on the CONTENT MENU
screen of APPLICATION mode.
• WhenPOWERSAVEMODEissettoON,thecontrolis
disabled in the standby mode.
• TocontrolthemonitorviaLAN,setRS-232C/LANSELECT
toLAN.(Seepage26.)
Set “Telnet Server” to “ON” on “Setup” in APPLICATION
mode. (See Software Guide.)
• YoucannotuseRS-232CandLANcontrolsimultaneously.
Controlling the Monitor with a computer (LAN)
Command-based control
YoucancontrolthemonitorusingRS-232Ccommands
(see page 39) via terminal software and other appropriate
applications.
Readthemanualfortheterminalsoftwarefordetailed
instructions.
(1) Connect the computer to the monitor.
1. Specify the IP address and data port number (10008)
and connect the computer to the monitor.
Whenconnectionhasbeenestablishedsuccessfully,
[Login:] is returned as response.
2. Sendtheusername.
• Send[username]+[
].
• Iftheusernameisnotset,send[
].
• Whenthetransmissionissuccessful,[
Password:]
is returned as response.
3. Send the password.
• Send[password]+[
].
• Ifthepasswordisnotset,send[
].
• Whenthetransmissionissuccessful,[OK
] is
returned as response.
(2) Send commands to control the monitor.
• ThecommandsusedarethesameasthoseforRS-
232C.Refertothecommunicationprocedure(see
page 35) for operation.
• UsablecommandsareprovidedintheRS-232C
command table (see page 39).
(3) Disconnect the connection with the monitor and
quit the function.
1. Send [QUIT ].
Whenthetransmissionissuccessful,[goodbye]is
returned and the connection is disconnected.
TIPS
• Connectionisautomaticallydisconnectedwhenthe
timespeciedinAUTOLOGOUTTIMEelapsesovera
no-communicationperiod.