Initialisation/Functional Restriction Setting (FUNCTION) menu
Function
Command Direction
Parameter Reply Control/Response contents *
ALL RESET
RSET W 0 No
ADJUSTMENT LOCK
ALCK WR 0-2 0-2 0: OFF Yes
OSD DISPLAY
LOSD WR 0-1 0-1 0: ON, 1: OFF Yes
LED OFLD WR 0-1 0-1 0: ON, 1: OFF Yes
Others
Function
Command Direction
Parameter Reply Control/Response contents *
SCREEN SIZE (PC) WIDE WR 1-5 1-5 1: WIDE, 2: NORMAL, 3: DotbyDot, 4: ZOOM1, 5: ZOOM2 Yes
SCREEN SIZE (AV)
WIDE WR 1-5 1-5 1: WIDE, 2: ZOOM1, 3: ZOOM2, 4: NORMAL, 5: DotbyDot Yes
VOLUME VOLM WR 0-31 0-31 Yes
MUTE MUTE WR 0-1 0-1 0: OFF, 1: ON No
INFORMATION
MODEL INF1 R Value
Yes
SERIAL NO
SRNO R Value
BRIGHT VLMP WR 0-31 0-31 Brightness Yes
TEMPERATURE SENSOR DSTA
R 0 Internal temperature normal
Yes
1 Internal temperature abnormal (Standby mode)
2 Internal temperature abnormal (Temperature is normal now, but it was
abnormal during operation.)
3 Internal temperature abnormal (Brightness of the backlight decreases.)
4 Temperature sensor abnormal
TEMPERATURE ACQUISITION ERRT
R Value Temperature at temperature sensors 1 through 3 are returned in the
following forms:
[Sensor 1], [Sensor 2], [Sensor 3]
Yes
CAUSE OF LAST STANDBY MODE
STCA W 0 Initialisation
Yes
R 0 No detectable error has occurred
1 Standby mode by POWER button
2 Main power “OFF” by the main power switch
3 Standby mode by RS-232C
4 Waiting mode by No Signal (Incl: VESA DPMS/DMPM)
6 Standby mode by abnormal temperature
8 Standby mode by SCHEDULE setting
Controlling the Monitor with a PC
To Next Page
Loading...
