Sharp PN-H701

14
E
Binding Cables
The cables connected to the terminals on the rear of the monitor can be fastened with the cable clamp.
Cable clamp
(insertion type)
Cable
*1 *2
*1
*1
*1
*1
*1
*1
*1
*1
*2 *2 *2
Cable clamp
attachment
Cable clamp
Cable
Power cord (Supplied)
Power cord clamp screw
Power cord clamp
Cable clamp
attachment
Connecting the Power Cord
Caution
• Use only the power cord supplied with the monitor.
1. Turn off the main power switch.
2. Plug the power cord (supplied) into the AC input terminal.
3. Plug the power cord (supplied) into the AC power outlet.
2
Power cord (Supplied)
AC input terminal
Main power switch
1
For power
outlet
3
Caution
• Do not tighten the screw excessively. Excessive
tightening may damage the monitor.