Sharp PN-H701

33
E
Control command table
How to read the command table
Command: Command eld (See page 31.)
Direction: W When the “Parameter” is set in the parameter eld (see page 31), the command functions as described
under “Control/Response Contents”.
R The returned value indicated under “Reply” can be obtained by setting “????” or “?
” in the
parameter eld (see page 31).
Parameter: Parameter eld (See page 31.)
Reply: Response (Returned value)
TIPS
• In the power standby state, the only command that is used is POWER CONTROL.
• When STANDBY MODE is LOW POWER, control via LAN is not possible in standby mode.
Power control/Input mode selection
Function Command Direction Parameter Reply Control/Response contents
POWER CONTROL POWR WR 0 0 Switches to standby mode.
1 1 Returns from standby mode.
INPUT MODE SELECTION ITGD W 0 Toggle change for input mode.
IAVD WR 1 1 HDMI1
2 2 HDMI2
3 3 HDMI3
4 4 HDMI4
5 5 D-SUB
6 6 MULTIMEDIA (USB port/Internal memory)
PICTURE menu
Function
Command Direction
Parameter Reply Control/Response contents
PICTURE MODE AVMD W 0 Toggle change for input mode.
1 AV
2 MOVIE
3 GAME
6 DYNAMIC
7 PC
9 sRGB
11 PHOTO
20 HIGH RESOLUTION
R 1 AV
2 MOVIE
3 GAME
6 DYNAMIC
7 PC
9 sRGB
11 PHOTO
20 HIGH RESOLUTION
BRIGHT VLMP WR -16-16 -16-16
CONTRAST CONT WR 0-40 0-40
BLACK LEVEL BLVL WR -30-30 -30-30
TINT TINT WR -30-30 -30-30
COLORS COLR WR -30-30 -30-30
SHARPNESS SHRP WR 0-20 0-20
Controlling the Monitor with a PC (RS-232C)