37
E
• When installing, removing or moving the monitor, ensure that this is carried out by at least 2 people.
• Be sure to use a wall-mount bracket designed or designated for mounting the monitor.
• This monitor is designed to be installed on a concrete wall or pillar. Reinforced work might be necessary for some materials
such as plaster / thin plastic board / wood before starting installation.
• This monitor and bracket must be installed on a wall which can endure at least 4 times or more the weight of the monitor.
Install by the most suitable method for the material and the structure.
• To attach a VESA-compliant mounting bracket, use M6 screws that are 3/8 inch (10 mm) to 1/2 inch (12 mm) longer than the
thickness of the mounting bracket.
Screw (M6)
Mounting bracket
Monitor mounting
3/8 - 1/2 inch (10 - 12 mm)
• Do not use an impact driver.
• When moving the monitor, be sure to hold it around the periphery. Do not grasp the screen. This may cause product damage,
failure, or injury.
• After mounting, please carefully ensure the monitor is secure, and not able to come loose from the wall or mount.
• Do not use any screw holes other than those for mounting brackets, located on the rear of the monitor, for installation.
• When using the monitor laying at on a surface (when the monitor is tilted 20 degrees or more upward or downward from the
perpendicular in relation to a level surface), consult an authorized SHARP dealer because there are some specic mounting
conditions.
Mounting Precautions
(For SHARP dealers and service engineers)
To Next Page
Loading...
