EN-11
Fitting the machine undercounter
If you wish to fit your machine undercounter, check whether you have sufficient
space under your countertop and whether the wiring-plumbing is suitable to
do so.1 If you decide that the space under the countertop is suitable for fitting
your machine, remove the worktop as shown in the illustration. 2
Warning:The stand part which we will settle our machine under it by removing
its worktop has to be stable in such a way not to allow balance disorder.
To remove the worktop, remove the screws that hold the worktop which are
located at the rear of the machine; then push the front panel 1 cm from the
front side towards the rear and lift it.
CHAPTER -3: INSTALLING THE MACHINE
To Next Page
Loading...
