Why won't my Sharp QW-I1GI47EX-FR Dishwasher start?
Several factors can prevent your Sharp Dishwasher from starting. Ensure the dishwasher is plugged in and switched on using the On/Off button. Check your indoor fuses and make sure the water inlet tap is open. Also, verify that the dishwasher door is fully closed and that the water inlet hose and machine filters are not clogged.
What to do if my Sharp QW-I1GI47EX-FR Dishwasher leaves partial food wastes on the dishes?
If your Sharp Dishwasher leaves partial food wastes on dishes, it could be due to several reasons. Avoid overloading the baskets and ensure dishes aren't leaning against each other; refer to the loading instructions. Use the correct amount of detergent as indicated in the programme table, and select the appropriate wash programme. Also, check if the spray arms are clogged with food waste and clean them with thin objects. Finally, ensure the filters and water drain pump are not clogged and are correctly fitted.
What to do if my Sharp QW-I1GI47EX-FR leaves whitish stains on dishes?
If you notice whitish stains on your dishes after a wash in your Sharp Dishwasher, it could be due to several reasons: * Not using enough detergent. Refer to the programme table for the correct amount. * Rinse aid dosage and/or water softener setting set too low. Increase the rinse aid and/or water softener level. * High water hardness level. Increase the water softener level and add salt. * Salt compartment cap not closed properly. Ensure the salt compartment cap is closed properly.
Why is there water remaining inside my Sharp QW-I1GI47EX-FR Dishwasher?
If water remains inside your Sharp Dishwasher, the drain hose might be clogged or twisted; inspect and clean or untwist it. Clogged filters could also be the cause, so clean them thoroughly. Alternatively, the programme might not be finished yet, so allow it to complete its cycle.
Why won't my Sharp Dishwasher dishes dry?
If your dishes aren't drying in your Sharp Dishwasher, ensure you've selected a programme with a drying option. Also, check that the rinse aid dosage isn't set too low and increase the rinse aid dosage setting if needed.
Why does detergent remain in the compartment of my Sharp QW-I1GI47EX-FR?
If detergent remains in the detergent compartment of your Sharp Dishwasher, ensure the compartment is dry before adding detergent.
How to fix rust stains on dishes in my Sharp QW-I1GI47EX-FR?
Rust stains on dishes from your Sharp Dishwasher can be caused by several factors. Ensure you are using dishwasher-proof sets, as the stainless-steel quality of some dishes may be insufficient. Adjust the water hardness level using the water hardness table if there's a high level of salt in the wash water. Also, check that the salt compartment cap is properly closed and use a funnel when filling the salt compartment to avoid spillage. For a poor mains grounding, consult a qualified electrician.
What to do if my Sharp QW-I1GI47EX-FR stops during washing?
If your Sharp Dishwasher stops mid-cycle, check the mains power supply. Also, verify that the water tap is on, ensuring a consistent water inlet.
Why is my Sharp QW-I1GI47EX-FR Dishwasher making shaking and hitting noises?
If you hear shaking and hitting noises during a wash cycle in your Sharp Dishwasher, the spray arm might be hitting dishes in the lower basket. Try moving or removing any items that are blocking the spray arm.
What to do for Sharp QW-I1GI47EX-FR Dishwasher water inlet system failure?
For a Sharp Dishwasher water inlet system failure, make sure the water inlet tap is open and water is flowing. Separate the inlet hose from the tap and clean the filter of the hose. Contact for service if the error continues.
General| Type | Freestanding |
|---|---|
| Size | Full-size |
| Height | 85 cm |
| Width | 60 cm |
| Depth | 60 cm |
| Delay start | Yes |
| Child lock | Yes |
| Place settings | 14 |
To Next Page