How to fix dishes not drying in Sharp Dishwasher?
If your dishes aren't drying in your Sharp Dishwasher, it could be because the drying option isn't selected; make sure to choose a program with a drying option. Also, the rinse aid dosage might be set too low, so increase the rinse aid dosage setting.
Why does detergent remain in the detergent compartment of my Sharp QW-NI13I49EX-EN?
If detergent remains in the detergent compartment of your Sharp Dishwasher, it's likely because the detergent was added when the compartment was wet. Ensure the detergent compartment is dry before adding detergent.
Why does my Sharp QW-NI13I49EX-EN Dishwasher leave whitish stains on dishes?
If you notice whitish stains on your dishes after a wash in your Sharp Dishwasher, there are several potential reasons. It could be due to not using enough detergent, so ensure you're using the correct amount as instructed. The rinse aid dosage or water softener setting might be too low; try increasing these levels. Also, a high water hardness level can cause this, so increase the water softener level and add salt. Finally, make sure the salt compartment cap is closed properly to prevent issues.
What to do if rust stains form on the dishes in my Sharp QW-NI13I49EX-EN Dishwasher?
If you're seeing rust stains on dishes washed in your Sharp Dishwasher, several factors could be at play. First, the stainless-steel quality of your dishes might be insufficient, so try using only dishwasher-proof sets. A high level of salt in the wash water could also be the culprit; adjust the water hardness level using the water hardness table. Ensure the salt compartment cap is closed properly. Avoid spilling too much salt while filling by using a funnel. Finally, a poor mains grounding might be the cause; in this case, consult a qualified electrician immediately.
General| Category | Dishwasher |
|---|---|
| Model | QW-NI13I49EX-EN |
| Type | Freestanding |
| Size | Full size |
| Place Settings | 13 |
| Energy Efficiency Class | E |
| Noise level | 49 dB |
| Delay start | Yes |
| Child lock | Yes |
| Dimensions (H x W x D) | 85 x 60 x 60 cm |
| Weight | 47 kg |
| Water consumption | 12 liters |
Read instructions carefully before use and keep manual for future reference.
Position machine in an area for easy loading and unloading of dishes.
Recommend fitting a filter to water inlet supply to prevent machine damage.
Use new water inlet hose supplied with machine; do not use old hose.
Machine operates at 220-240V. Use 110V transformer if needed.
Diagram showing main dishwasher parts, labeled 1-12.
Details on capacity, dimensions, weight, voltage, current, power, and water pressure.
Check specs, remove packaging, set softener, and fill rinse aid before first use.
Explains need for soft water and the role of dishwasher salt for performance.
Instructions for opening salt compartment and filling with salt and water.
Guide on using a test strip to determine water hardness.
Table correlating water hardness levels (dH, dF, dE) with indicator LEDs.
Dishwasher has a water softener to reduce mains water hardness.
Steps to change the salt level setting on the machine.
Instructions for using detergents specifically designed for domestic dishwashers.
How to open the detergent dispenser and pour in detergent.
Recommendations and precautions for using combined detergents.
Explains rinse aid function for drying dishes without streaks and stains.
Instructions for filling rinse aid compartment and adjusting rinse aid level.
Guidelines for loading dishes for best results, energy, and water savings.
Examples of suitable and unsuitable items for loading into lower and upper baskets.
How to switch the machine on and off using the On/Off button.
How to select a suitable program using the Program Selection button.
Function of the Half Load button to reduce duration, energy, and water consumption.
How to delay the start time of a program for 3, 6, or 9 hours.
Steps to cancel a program while it is in operation.
Procedure for switching the machine off after a program is complete.
Instructions on cleaning filters and spray arms at least once a week.
Ensure spray holes are not clogged; how to remove and clean them.
Procedure for cleaning the waste water pump and removing foreign objects.
To Next Page