GB-19
ENGLISH
BEFORE OPERATION
Plug in the oven. The oven display will display: “0:00”, an audible signal will sound once.
This model has a clock function and the oven uses less than 1.0W in stand by mode. To set the clock, see below.
SETTING THE CLOCK
There are two setting modes: 12 hour clock and a 24 hour clock.
1. To set the 24 hour clock, press the CLOCK/KITCHEN TIMER button once and “24H” will appear in the display. To
set the 12 hour clock, press the CLOCK/KITCHEN TIMER button once more and “12H” will appear in the display.
2. Rotate the ENTRY dial until the correct hour is displayed, the input time should be within 0-23 (24-hour
clock) or 1 -12 (12-hour clock).
3. Press the CLOCK/KITCHEN TIMER button, the minute gure will ash.
4. Set the minutes. Rotate the ENTRY dial until the correct minutes are displayed, the input time should be
within 0-59.
5. Press the CLOCK/KITCHEN TIMER button once to start the clock. The icon “:” of the digital time will be
ashing on the display.
NOTES:
• If the clock is set, when cooking is complete, the display will show the correct time of day. If the clock has not
been set, the display will show “0:00”.
• To check the time of day during a cooking process, press CLOCK/KITCHEN TIMER button and the LED will
display the time of day for 2-3 seconds. This does not a ect the cooking process.
•
In the process of clock setting, if the STOP/CLEAR button is pressed, the oven will go back to the former setting.
•
If the electrical power supply to your microwave oven is interrupted, the display will intermittently show “0:00
”
after the
power is reinstated. If this occurs during cooking, the programme will be erased. The time of day will also be erased.
MICROWAVE POWER LEVELS
Power Level Press the MICRO.
POWER button
Display
(Percentage)
• Your oven has 5 power levels, as shown.
• To change the power level for cooking, press the
MICRO. POWER button or rotate the ENTRY dial
until the display indicates the desired level. Press
the START/+1min/ENTER button to confirm, enter
the cooking time and then press the START/+1min/
ENTER button to start the oven.
• To check the power level during cooking, press the
MICRO. POWER button, the current power level will
be displayed for 2-3 seconds. The oven will continue
to count down although the display will show the
power level.
HIGH x1 P100
(100%)
MEDIUM
HIGH
x2 P80
(80%)
MEDIUM x3 P50
(50%)
MEDIUM LOW
(DEFROST)
x4 P30
(30%)
LOW x5 P10
(10%)
Generally the following recommendations apply:
P100
- (HIGH output = 900W) used for fast cooking or
reheating e.g. for casseroles, hot beverages, vegetables etc.
P80 - (MEDIUM HIGH output = 720W) used for longer
cooking of dense foods such as roast joints, meat loaf
and plated meals, also for sensitive dishes such as
sponge cakes. At this reduced setting, the food will
cook evenly without over cooking at the sides.
P50 - (MEDIUM output = 450W) for dense foods
which require a long cooking time when cooked
conventionally, e.g. beef casserole, it is advisable to use
this power setting to ensure the meat will be tender.
P30 - (MEDIUM LOW output = 270W) Defrost setting)
to defrost, select this power setting, to ensure that
the dish defrosts evenly. This setting is also ideal for
simmering rice, pasta, dumplings and cooking egg
custard.
P10 - (LOW output = 90W) For gentle defrosting, e.g.
cream gateaux or pastry.
To Next Page
Loading...
Need help?
General
