38
Remove door assembly, refer to "Door Replacement".
Replacement of door components are as follows:
CHOKE COVER
1. Place door assembly on a soft cloth with latches facing up.
Note: As the engaging part of choke cover and door panel are
provided at several places, do not force any particular part.
2. Insert an putty knife (thickness of about 0.5mm) into the gap
between the choke cover and corner portion of door panel
as shown Figure C-6 to free engaging parts.
3. Lift up choke cover.
4. Now choke cover is free from door panel.
NOTE: When carrying out any repair to the door, do not
bend or warp the slit choke (tabs on the door
panel assembly) to prevent microwave leakage.
DOOR DISASSEMBLY
CHOKE COVER
PUTTY KNIFE
FRONT
INSIDE
Upper
Lower
Bent
Door
Panel
Choke
cover
1 BENT
2 LIFT UP
DOOR PANEL
5. Remove the eleven (11) screws holding the door panel to
the door frame.
NOTE: The one (1) screw of the eleven (11) screws also
holds the earth terminal of the door decoration to the
door frame.
6. Remove the door panel from the door frame. Now the door
panel is free.
DOOR GLASS
7. Remove the two (2) screws holding the thermal plate U to
the door frame.
8. Remove the two (2) screws holding the thermal plate R to
the door frame.
9. Remove the thermal plate U and the thermal plate R from
the door frame.
10.Slide the door glass leftward.
11.Slide the door glass upward.
12.Remove the door glass from the door frame. Now the door
glass is free.
DOOR DECORATION AND DOOR FRAME
13.Straighten all tabs of the door decoration.
14.Remove the door decoration from the door frame.
15.Now the door decoration and door frame are free.
Figure C-6. Door Disassembly
RE-INSTALL
RE-INSTALL
LOWER OVEN HINGE
UPPER OVEN HINGE
DOOR ASSEMBLY
LATCH
HEADS
Note: The door on a microwave oven is designed to act as
an electronic seal preventing the leakage of
microwave energy from oven cavity during cook
cycle. This function does not require that door be
airtight, moisture (condensation)-tight or light-tight.
Therefore, occasional appearance of moisture, light
or sensing of gentle warm air movement around
oven door is not abnormal and do not of themselves
indicate a leakage of microwave energy from oven
cavity. If such were the case, your oven could not
be equipped with a vent, the very purpose of which
is to exhaust the vapor-laden air from the oven
cavity.
Figure C-5. Door Replacement and adjustment
SMC1585BSA
SMC1585BBA
SMC1585BWA
To Next Page
Loading...
