Sharp UP-600

POS TERMINAL
MODEL
UP-600
UP-700
(For "U" & "A" version)
CHAPTER 1. SRV. RESET AND MASTER RESET ........................................2
CHAPTER 2. READING OF SRV MODE PROGRAM .....................................3
CHAPTER 3. SRV MODE PROGRAMMING ("2 SETTING").........................10
CHAPTER 4. SRV MODE PROGRAMMING ("3 IRC SETTING")..................45
CHAPTER 5. SRV MODE PROGRAMMING ("4 DOWN LOAD") ..................48
CHAPTER 6. SRV MODE PROGRAMMING ("5 DIAGNOSTICS")................49
For setting in PGM1 or PGM2 mode, refer to the Operation Manual.
CONTENTS
Parts marked with " " are important for maintaining the safety of the set. Be sure to replace these parts with specified
ones for maintaining the safety and performance of the set.
SHARP CORPORATION
This document has been published to be used
for after sales service only.
The contents are subject to change without notice.
UP-600
UP-700