Sharp UP-820F

33
■ Balance report
■ Bill report
■ X1/Z1 stacked report
You can print multiple X1/Z1 reports in sequence under a single transaction. In this case you need to
program in advance which X1/Z1 reports should be printed. Refer to “Stacked report” under Section “Report
Programming” in Chapter 12 “Programming” of INSTRUCTION MANUAL.
Clerk code
Amount
Bill number
Date
When you take a Z report, “Z1” is printed instead of “X1”.
Grand total balance of the previous day
Order total
Paid total
Old balance + today’s balance