18
Dimensions: 257 ⳯ 182 mm
FLE (M) Sdn. Bhd.VC-A420U (16-20)
Setting the Clock
Automatic Daylight Saving-Time (D.S.T.) Adjustment
This VCR is equipped with an internal Automatic Daylight Saving-Time Adjustment function. In spring (first
Sunday in April) and autumn (last Sunday in October), the time is adjusted as shown below. This function has
been preset to ON at the factory. Set the D.S.T. mode in the clock setting screen.
Spring
Programmed timer recording set within this time frame (2:00
AM to 3:00 AM) will not be carried out.
First Sunday in April (D.S.T. is ON)
Autumn
Because there will be two time frames from 1:00 AM to 2:00
AM, timer programming set between these times will be
influenced by the time change.
Last Sunday in October (D.S.T. is ON)
The clock is automatically
advanced 1 hour.
䢇
䢇䢇
䢇
3:00 AM
1:00 AM 2:00 AM
4:00 AM
The clock is automatically
set back 1 hour.
䢇
䢇䢇
䢇
2:00 AM
2:00 AM1:00 AM
1:00 AM
• If the timer recording program is affected by the D.S.T. time change, check your TV listing and find out when it reflects the
time change. Some TV listings will indicate the time change in the same manner as is programmed in this VCR, but others
do not show the time change until the next morning. In that case, when programming a timer, use the CLOCK screen to set
the D.S.T. mode to OFF so the time change will not be carried out.
• In Step !, if you press MENU when operating the screen setting for the first time or after the power is interrupted for more
than 5 seconds, the LANGUAGE screen will appear.
• If you entered incorrect data during the setting procedure, re-enter the correct data in the following manner:
1 Use ß /© to select the data to be corrected.
2 Set the correct data with ∂ /ƒ.
3 After correcting the data in Step 2, press SET to enter.
• If you press MENU to exit the CLOCK screen in Step %, the data will not be stored.
• If a button is not pressed within 3 minutes during the setting procedure, the screen will return to the normal screen.
% If the data is correct, press SET to enter.
The screen returns to normal.
Normal
Screen
佡
SELECT : CHANGE:
10:28
AM
7/04WED 01 ON
CLOCK
ENTER :SET EXIT :MENU
TIME DATE YEAR DST
ß /©
and
∂/ƒ
# Select “TIME” with ß/© and set time by holding ∂/ƒ.
Ex.: 10:28 AM
Numbered buttons can be used instead of ∂/ƒ to set
time and date. Press AM/PM (100) to select AM or PM
during time setting.
$ Select and set “DATE”, “YEAR” and “DST” in turn, in the
same manner as in Step #.
• See Automatic Daylight Saving-Time (D.S.T.) Adjust-
ment.
Ex.: Jul. 4, 2001, DST: ON
To Next Page
Loading...
