16
Dimensions: 257 ⳯ 182 mm
VC-A560U (11-16)
EZ Set Up (With Auto Clock Setting)
IMPORTANT (Caution during EZ Set Up):
• Do not press the POWER button on the VCR
or remote control.
• Do not insert a video cassette into the VCR.
The EZ Set Up function automatically sets the tuner channels and clock when the antenna cable is connected to
the rear of the VCR and the power plug is then connected to an AC outlet.
IMPORTANT:
When using a cable box:
• See Cable TV Connections.
• Leave POWER on the cable box turned on and select a channel that carries EDS signals.
During Auto Channel Setting and
Auto Clock Setting
Flashes quickly
佣
EZ Set Up complete
Flashes slowly
! Make sure that the antenna cable is
connected. For connection configuration, refer
to Connecting the VCR.
@ Connect the VCR power plug to an AC outlet.
# The tuner channels and clock will automatically
be set. The POWER LED indicator will flash
quickly to indicate the setting.
• This VCR can monitor and use time-signals
(EDS signals), which are provided by some
TV stations, to automatically adjust the VCR
clock. This VCR automatically searches EDS
signals, but if you are in a hurry to use timer
recording or know the channel of the EDS
signal carrier in your area, follow the
procedure in Auto Clock Setting or Manual
Clock Setting.
$ When the setting is completed, POWER LED
indicator will flash slowly.
• If power is supplied to the VCR before the cable is connected, EZ Set Up will not be able to preset the channels into
memory. If this occurs unplug the VCR from the power source and wait a few minutes. Check the cable /antenna connection
and supply power to the VCR. EZ Set Up will automatically begin again.
• If the power is turned on during EZ Set Up, the Auto Channel setting will be interrupted and the tuner channels will not be
able to be preset.
• Auto Clock Setting may take several minutes.
• If the Auto Clock Setting is not completed within 30 minutes, there may be no channels with EDS signals. In this case, set the
clock manually. (See Manual Clock Setting.)
• If the antenna signal is weak, the Auto Clock Setting function may not operate.
• During initial channel setting, the channels are set into the AIR channel setting. To watch a cable TV channel, select “CATV”
on the CHANNEL PRESET screen. (See Setting the Channels.)
To Next Page
Loading...
