39
VC-A560U(A)/A560U/A560U(B)
VC-H960U/H960U(B)/H961U
FLOW CHART NO.6
No operation is possible from the infrared remote control.
Operation is possible from the VCR,
but no operation is possible from the
infrared remote control.
Is the supply voltage of 5V feed to
pin(3) terminal of remote control
receiver?
Check AT 5V lines.
Is "L" pulse sent out pin(1) terminal of
receiver when the infrared remote
control is activated?
Replace the remote control receiver
or replace the remote control
transmitter if necessary.
Is inputted "L" pulse to pin(4) of
IC701?
Check line between at remote
control receiver thru to pin(4) of
IC701.
YES
YES
NO
NO
NO
YES
Replace IC701.
YES
FLOW CHART NO.7
A cassette tape is not take in.
YES
YES
YES
NO
NO
NO
Check start sensor shutter.
Check line start sensor and all the
way up thru to pin(67) of IC701.
Check line pin(72) of IC701 and all
the way up thru to pin(10) of P701.
Replace loading motor.
Does pin(10) of P701 go from 2.5V
to 4.2V when the cassette tape is
inserted.
Does pin(67) of IC701 change from
"H" to "L" level when the cassette
tape is inserted?
Are start sensor shutter go to open
when the cassette tape is inserted?
NO
NO
NO
FLOW CHART NO.8
A cassette tape is taken in, but ejected at once.
Does the start sensor pulse at
pin(67) of IC701 change from "L" to
"H" level when the cassette tape is
loaded?
Check start sensor and all the way
up thru to IC701.
Does the end sensor pulse at pin(66)
of IC701 change from "L" to "H" level
when the cassette tape is loaded?
Check end sensor and all the way
up thru to IC701.
Does the master cam mode shifter
operate normally when the cassette
tape is loaded?
Check cam switch and all the way
up thru to IC701.
Replace IC701.
YES
YES
YES
To Next Page
Loading...
