Sharp VC-H961U

Ref. No. Part No. ★ Description Code
Ref. No. Part No. ★ Description Code
84
VC-A560U(A)/A560U/A560U(B)
VC-H960U/H960U(B)/H961U
PRECAUTION ON FRONT PANEL SET-UP
Cassette cover
Cassette cover
open lever
Cassette housing
Cassette cover
open lever
Cassette cover
open lever
Cassette cover
About 45°
Front panel
1
5
2
4
3
Removing the cassette compartment cover.
1Open the cassette compartment cover
fully.
2Remove the center positioner.
3Slide the cover to the right.
4Slightly bend the cover.
5Draw out the left-side rod.
Do not mount the front
panel with the cassette
cover tilted too open.
Otherwise the cassette
cover might wrongly run
on the cassette housing.
Keep the cassette over about
45° open and make sure that
the cassette cover open le-
ver is between the front panel
and the cassette cover. Now
fix the front panel in place.
Before attaching the front
panel in position, make
sure that the cassette cover
open lever is in its right
place (lower-most). If it is
out of position, push it down
with a finger.
A
B
C
D
E
F
123456
FRONT PANEL PARTS(VC-H961U)
500-7
500-1
500-3
500-2
500-11
500-6
500-4
500
501
502