Sharp VIEWCAM VL-A110U - Recording the Date and Time

VL-A110U/pp. 026-039; 00/11/21/18:00
G. K. Associates, Tokyo
26
Useful Features
5 Press the 쑽 button to select “SELECT”.
6 Press the SET button (B) to select
“DATE+TIME” or “DATE”.
When “DATE+TIME” is selected, both the
date and the time are displayed and
recorded.
When “DATE” is selected, only the date
is displayed and recorded.
7 Press the DISPLAY button to turn off the
menu screen, and then press the REC
START/STOP button to begin recording.
Recording the Date and Time
Follow the procedure shown below to record
the date and time, or the date only, along with
the subject.
Note:
• Before performing the procedure below, make
sure that the date and time have been correctly
set (see page 16).
1 In Recording Standby mode, press the
MENU button until
(MENU 1)
appears.
2 Press the PAGE button ( ) to display
MENU 2.
3 Press the 쑽 or 쒀 button to select
“DISPLAY”.
SET
JU
10 AM30
N 2 2001
MENU
12H
DATE
DISPLAY OFF
SETTING
12H 24H
SELECT DATE TIME
+
TIME/
/
2
JU
10 AM30
N 2 2001
MENU
12H
DATE
DISPLAY OFF
SETTING
12H 24H
SELECT DATE TIME
+
TIME/
/
2
PAGETURE
PIC
-
SET
5
PAGE
4 Press the SET button (B) to select
“AUTO”, “ON”, or “OFF”.
SET
MENU
DATE
DISPLAY OFF
SELECT DATE TIME
+
TIME/
2
When “AUTO” is selected, the date/time
is displayed and recorded for 10
seconds at the beginning of the first
recording of each day.
When “ON” is selected, the date/time is
continuously displayed and recorded.
When “OFF” is selected, the date/time is
neither displayed nor recorded.
Note: In “AUTO”, if you wish to record the
date/time a second time that day, repeat the
procedure above and re-select “AUTO”.
SET
JU
10 AM30
N 2 2001
MENU
12H
DATE
DISPLAY AUTO
SETTING
12H 24H
SELECT DATE TIME
+
TIME/
/
2
SET
MENU
DATE
DISPLAY AUTO
SELECT DATE TIME
+
TIME/
2
JU
10 30 AM
N 2 2001