4-16
VL-E610S/VL-E610H
VL-E660S/VL-E96E
VL-E98E
(2) Drum motor stator
Remove the stator mounting screw with the hexagonal wrench as shown in Figure 2, remove the motor stator.
Figure 4
Figure 2
Upper/lower drum ass'y
Motor stator
Stator mounting screw
Phase matching hole
(3) Upper drum ass’y
Remove the upper drum ass’y from the lower drum ass'y as shown in Figure 3.
At this time take care so as not to lose the gap shim.
Figure 3
(4) Motor rotor ass'y and rotary transformer rotor ass'y
Remove the 2 rotor mounting screws as shown in Figure 4, and remove the motor rotor and the rotary transformer ass'y.
Upper drum ass'y
Gap shim
Lower drum ass'y
Motor rotor
Positioning hole
Upper drum ass'y
Rotor mounting screw
Positioning pin
To Next Page
Loading...
