MX-M200D SPECIFICATIONS 3-2
(3)Types of feedable paper
F. Multi copy
G. Warm-up time
H. Copy magnification ratio
I. Print density
J. Void width
K. Paper exit / finishing
L. Additional functions
O : Available X : Not available
Types of paper 1st tray 2nd tray Bypass tray
Thin paper
56-59g/m
2
15-15.9lbs
Ye s Ye s Ye s
Plain paper
60-90g/m
2
16-24lbs
Ye s Ye s
Ye s
(Multi paper
feed enable)
Heavy paper
91-105g/m
2
16-24lbs
N/A N/A
Ye s
(Multi paper
feed enable)
Heavy paper
106-128g/m
2
24.1-33.5lbs
N/A N/A
Ye s
(A4 or less)
(Multi paper
feed enable)
Heavy paper
129-200g/m
2
33.6-53.2lbs
N/A N/A
Ye s
(A4 or less)
(Only single
paper feed)
Heavy paper
201-256g/m
2
53.3-68lbs
N/A N/A N/A
Envelope
75-90g/m
2
20-24lbs
N/A N/A Ye s
Postcard N/A N/A Ye s
OHP film N/A N/A Ye s
Label sheet N/A N/A Ye s
Tab paper 20 N/A N/A No
Max. number of
multi copy
999 sheets
Warm-up time 45 seconds or less
Pre-heat Available
Jam recovery Within 45 sec
Fixed
magnification
ratio
AB system:
400, 200, 141, 122, 115, 100, 86, 81, 70, 50, 25%
Inch system:
400, 200, 141, 129, 121, 100, 95, 77, 64, 50, 25%
Zooming 25 ~ 400%
SPF/RSPF(50 ~ 200%)
Independent
zooming(vertical)
Available (25 ~ 400%)
SPF/RSPF(50 ~ 200%)
Independent
zooming
(horizontal)
Available (25 ~ 400%)
SPF/RSPF(50 ~ 200%)
Density mode Auto / Text / Photo
No. of manual
adjustment
5 steps (Text / Photo)
Resolution Writing: 600 x 600dpi
Reading: 600 (main) x 600 (sub) (PHOTO mode)
600 (main) x 300 (sub) (AUTO exposure
mode)
600 (main) x 300 (sub) dpi (TEXT mode)
Gradation Reading: 256 gradations
Writing: Binary
Toner save mode Set by the user program
Void area Lead edge 1 ~ 4mm,
rear edge 4mm or less,
Total of both sides: 6mm or less
Image loss 4.0mm or less
Paper exit section
capacity
Face down 250 sheets
Full detection Detection of 250 sheets count is for only copy mode
When the job separator is installed, only detection
is available
Upper stage: 100 sheets or 10.6mm or less
Lower stage: 150 sheets
Finishing Shifter (Standard except for North America)
Job separator (Option)
Electronic sort
capacity
A4/ 8.5" x 11" standard document (6% coverage)
160 sheets
Offset function Yes (Except for North America)
Staple function None
APS O
AMS O
Auto tray switching O
Memory copy O
Rotation copy O
E-sort
(Sorting function)
O Single surface, A4, Max. 80 sheets
E-sort (Grouping
function)
O
Rotation sort X
Prevention of sky
shot
X
Independent
zooming
O
1 set 2 copy O SPF: Disable
OC: Enlargement is disable.
Binding margin O
Default AB series: 10mm (5, 10, 15, 20mm)
Inch series: 1/2 inch (1/4, 1/2, 3/4, 1 inch)
Edge erase O
Default AB series: 10mm (5, 10, 15, 20mm)
Inch series: 1/2 inch (1/4, 1/2, 3/4, 2 inch)
Center erase O
Default AB series: 10mm (5, 10, 15, 20mm)
Inch series: 1/2 inch (1/4, 1/2, 3/4, 3 inch)
Black/white
reverse
X
Multi shot O
Offset X
Preheating O The conditions are set by the user program.
Auto shut-off O The conditions are set by the user program.
User programming O
Total counter O Supports Total counter and Copy counter and
Scanner counter.
Coin vendor
support
O (Supports I/F only.)
Auditor support O (Supports I/F only.)
Toner save O (Set according to the destination)
Department
management
O (Total of copy, printer, and scanner: 50 Dept.,
Fax: 50 Dept.)
To Next Page
Loading...
Need help?
General
