Sharp XG-P25X - Page 48

To Next Page

To Previous Page

XG-P25X

TROUBLE SHOOTING TABLE FOR PC I/F UNIT (Continued)

Feed the component signals to the

INPUT 1 or INPUT2 terminal.

Using the control panel key or the

remote controller, select INPUT1

or INPUT2.

Do the process adjustment.

Set the signal type to the

component.

Checking the component input

(4801 not included)

Does the image appear?

Go to "Checking the SOG circuit".

Are the colors as specified?

Is the signal type set for the

component?

Is the image contour as specified?

IC8004 or IC8025 defective.

The component signals are as

specified. End.

YES

Other manuals for Sharp XG-P25X