COMPACT DISC OPERATION
■ Care of compact discs
Compact discs are fairly resistant to damage,
however mistracking can occur due to an accu-
mulation of dirt on the disc surface.
Follow the guidelines below for maximum enjoy-
ment from your CD collection and player.
● Do not write on either side of the disc, partic-
ularly the non-label side. Signals are read from
the non-label side. Do not mark this surface.
● Keep your discs away from direct sunlight,
heat, and excessive moisture.
● Always hold the CDs by the edges. Finger-
prints, dirt, or water on the CDs can cause
noise or mistracking. If a CD is dirty or does
not play properly, clean it with a soft, dry cloth,
wiping straight out from the centre, along the
radius.
■ CD playback
1 Press the ON/STAND-BY button to turn the
power on.
2 Press the FUNCTION button until "Cd" ap-
pears in the display.
● Press the CD button on the remote control.
3 Press the
7
CD EJECT button to open the
CD compartment.
4 Place a compact disc on the spindle, label
side up.
5 Close the CD compartment by firmly pushing
the corner marked "PUSH CLOSE".
● The total number of tracks and the total playing
time will be displayed.
6 Press the
0
/ CD
6
(
0 6
) button to start
playback from track 1.
● When the last track on the disc has finished
playing, the unit will stop automatically.
To interrupt playback:
1 Press the
0
/ CD
6
(
0 6
) button.
2 Press the
0
/ CD
6
(
0 6
) button again to
resume playback from the same point.
To stop playback:
Press the ■ button.
After use:
Press the ON/STAND-BY button to enter the
stand-by mode.
NO
YES
Correct
3
45
1
2
6
2
1
6
XL-530E(SUK) TINSE0017SJZZ
7
To Next Page
Loading...
