E-20
ENGLISH
XL-E2H
6
9
1
2
3
4
5
7
8
Tape Playback
Listening to the memorised station
Memorising a station
Up to 20 stations for FM band, 10 station for AM band can be preset.
Note:
The backup function protects the memorised stations for a few hours
should there be a power failure or the AC power lead become
disconnected.
Listening to preset stations
Listening to a cassette tape
1 Perform steps 1 - 3 in "Listening to the radio" on page 19.
2 Press the MEMORY/DISP button to enter the preset tuning
saving mode.
3 Press the PRESET ( or ) button to select the channel to
be preset.
z The number button(s) on the remote control can be used to pre-
set the station. In this example, press 9 after the step 2 above.
4 Press the MEMORY/DISP button.
In this example, "103.25 MHz" FM station is preset on FM
channel 9.
5 Repeat steps above to add more preset stations.
z When presetting a new station, the previous preset station is
cleared.
1 Press the TUNER (BAND) button to select FM or AM.
2 Press the PRESET ( or ) button to select the desired
channel number.
MEMORY
MEMORY
MEMORY MEMORY
MHz
Before playback:
z For playback, use normal or low-noise tapes for the
best sound.
(Metal or CrO
2
tapes are not recommended.)
z Do not use C-120 tapes or poor-quality tapes, as they
may cause malfunctions.
z Before loading a tape into the cassette compartment,
tighten the slack with a pen or a pencil.
To Next Page
Loading...
Need help?
General
