Sharp YB-S1282AE - Page 17

EN-16
COUNTER CHECK
Set the counters to “0” before using your new oven (see COUNTER CLEAR below) to keep a record of the oven use.
Example: If you want to know the total amount of times the oven has been used, and the number of times each
programme has been used. In the following example, the total time was 8268 and memory 1 was 513 .
Step Procedure Key Order Display
1 Press the CHECK key twice.
X2
CHECK will flash on and off.
(Total times used)
2 To check memory 1 usage, press
the NUMBER key
.
After about 1 sec.
(Times memory 1 was used)
Note:
Note:
1. To cancel Counter clear mode, press the CHECK key
.
2. To clear the times of manual cooking, press the SELECT TIME key at Step 2 instead of the NUMBER key.
To clear the times of EXPRESS DEFROST cooking, press the EXPRESS DEFROST key
at
Step 2 instead of the NUMBER key.
3. To clear total using times, skip Step 2.
COUNTER CLEAR
Each number of times can be cleared.
Example: Suppose you want to clear the times of memory 1.
Step Procedure Key Order Display
1 Press the CHECK key twice.
X2
CHECK will flash on and off.
(Total times used)
2
Press the NUMBER key
.
After about 1 sec.
(Times memory 1 was used)
3
Press the SET key.
1. To cancel Counter Check mode, press the CHECK key .
Each counter can count the times up to 9999, and it will return to 0 if it is over 9999.
To check the times of manual cooking, press the SELECT TIME key
at Step 2 instead of the
NUMBER key.
To check the times of EXPRESS DEFROST cooking, press the EXPRESS DEFROST key
at
Step 2 instead of the NUMBER key.