Be sure to perform the following procedures before using the Organizer
for the first time:
1. Remove the insulation sheet.
Note:
When you remove the insulation sheet, write down the date on
the label on the back of the Organizer (refer to page 101).
2. Initialize the Organizer.
While holding
[ml
, press the RESET switch on the back. Release
the RESET switch and then release
m]
. The following display
will appear:
Data has
been broken!
Clear all
CAPS
i’
Note:
Under certain conditions the message may appear as “DATA
ALL CLEAR OK (Y/N)?“. Proceed to the next step in either case.
Press
vi.
*
TEL 1 4
NAME
?
CAPS
i’
The Organizer is initialized and then the TEL1 directory is displayed.
,
To Next Page
Loading...
