-3-
HOW TO USE THE HEATED INDOOR/OUTDOOR SLIPPERS
1. Locate the USB plug on Heated Indoor/Outdoor Slippers and connect it to the 5v power bank.
2. Press the power button on the power bank to activate the battery. Then locate the power button
on the slippers to activate the heating system.
3. Press and hold down the power button on the slipper for 3 seconds. It will light up and cycle from
RED (high), to BLUE (medium/high), to GREEN (low) and then back to RED (high). Note: This is
a pre-heat cycle that will take 5 minutes. Once the 5-minute pre-heat cycle is complete the
product will automatically turn down to the BLUE (medium/high) setting. You can change the
power level setting at any time by pushing the power button.
4. To turn the slippers off, press and hold the power button for 3 seconds or disconnect the USB
plug from the 5v power bank. Note: The Heated Indoor/Outdoor Slippers should only be used with
the included power bank and USB cable. Never use a power bank or cable with any other device
regardless of how similar the plugs may appear to fit or work together.
TEMPERATURE SETTINGS
• Blue: Medium/High heat – 110° F with approximate run time of 4.5 hours
• Green: Low heat – 95° F with approximate run time of 7 hours
• Red: High heat – 130° F with approximate run time of 3 hours
NOTE: We recommend users wear socks while wearing the slippers.
SIZING INFORMATION
Small: Women’s US 5/6
Medium: Men’s US 6 - 7.5 / Women’s US 6.5 - 8
Large: Men’s US 8 - 9.5 / Women’s US 8.5 - 10
X-Large: Men’s US 10 - 11.5 / Women’s US 10.5 - 12
XXL: Men’s US 12-13
CLEANING AND MAINTENANCE
• Remove the battery and USB cable before washing
• It is recommended to place the product in a pillowcase or laundry bag for protection while
washing
• Wash in cold water with a mild detergent
• After washing, put in the dryer on tumble dry. Be sure the product and USB plug are completely
dry before using again
To Next Page
Loading...
