AFTER SALES SUPPORT
Email: service@prolinkbrands.co.nz
Phone: 0508 776 546 - Mon-Fri 8:30am – 4.30pm Page 12
2. Connect the windows kit adapter to the
other end of the exhaust hose.
3. Extend the adjustable sliding window kit to the
length of your window. Connect the exhaust hose to
the window kit.
4. Close your window to secure the kit in place. It
needs to hold the window kit firmly in place,
secure the window kit with duct tape if required.
It is recommended that the gap between the
adapter and the sides of the window should be
sealed off for maximum efficiency.
5. Attach the hose connector to the exhaust air outlet of the
unit.
6. Adjusting the length of the flexible exhaust hose,
and avoid bends in the hose. Then place AC near an
electrical outlet.
7. Adjust the louvre at the air outlet, and then switch on the unit.
To Next Page
Loading...
