AFTER SALES SUPPORT
Email: service@prolinkbrands.co.nz
Phone: 0508 776 546 - Mon-Fri 8:30am – 4.30pm Page 17
CLEANING and MAINTENANCE
This appliance contains no user-serviceable parts. Any servicing requiring disassembly
other than cleaning must be performed by a qualified appliance repair technician.
Before Cleaning
Before unplugging the unit ensure all controls are set off.
When not in use or before cleaning, always disconnect the appliance from the
mains supply.
Care and Cleaning
Accumulated dust may be removed from the appliance surface with a dry soft
cloth.
For more thorough cleaning, use a cloth that is slightly moist with a solution of
mild detergent and water.
Never use rough scouring pads or abrasive cleansers on any plastic or metal parts
as the surface may be damaged.
Dry the appliance casing thoroughly with a soft, dry cloth before operating the
unit again.
Filters
Dust collects on the filters and restricts the airflow. The restricted airflow reduces the
efficiency of the system and if it becomes blocked it can cause damage to the unit.
The air filter requires regular cleaning. The air filter is removable for easy cleaning.
Do not operate the unit without an air filter, or the evaporator may be contaminated.
1. Press the POWER button to switch off the unit and unplug the power cord.
2. Remove the filter mesh from the unit.
3. Use a vacuum cleaner to suck dust from the filter.
4. Turn the filter over and rinse the air filter under running water. Let the water run
through the filter in the opposite direction of airflow. Set aside and allow the filter
to air dry completely before reinstalling.
To Next Page
Loading...
