AFTER SALES SUPPORT
Email: service@prolinkbrands.co.nz
Phone: 0508 776 546 - Mon-Fri 8:30am – 4.30pm Page 18
Switch off the unit and remove
the two air filters.
Rinse the air filter under running
water.
Warning!!! Do not touch the evaporator surface with bare-hand, or may
cause injury to your fingers.
Storing the Air Conditioner
If the machine will be unused for a long period store your appliance and all its
accessories and instruction manual in a safe and dry place.
1. Unplug the unit and remove the exhaust hose and window kit store with the unit.
2. Drain the remaining water from the unit.
3. Clean the filter and let the filter dry completely in a shaded area.
4. Collect the power cord at the water tank.
5. Re-install the filter at its position.
6. The unit must be kept in an upright position when in storage.
7. Preserving the machine in ventilating, dry, non-corrosive gas and safe place
indoor.
ATTENTION:
The evaporator inside the machine has to be dried out before the unit is packed to
avoid component damage and mould. Unplug the unit and place it in a dry open area
for days to dry it out. Another way to dry the unit is to set the humidity point more
than 5% higher than the ambient humidity to force the fan to dry the evaporator for a
couple of hours.
To Next Page
Loading...
