AFTER SALES SUPPORT
Email: service@prolinkbrands.co.nz
Phone: 0508 776 546 - Mon-Fri 8:30am – 4.30pm Page 13
OPERATION
Before First Use
After unpacking, ensure that the contents are complete and check for any transit
damage in order to avoid any danger. Do not use it if in any doubt, but contact our
customer service team.
To protect against damage during transit, your appliance is packaged.
Remove the appliance carefully from its sales packaging.
Remove all packaging elements.
Keep all packaging away from Children. Danger of suffocation.
Clean the appliance and all accessories to remove all packaging dust according to
the instructions in the chapter “CLEANING AND MAINTENANCE".
Operation of the appliance
Before each use of the appliance, ensure that all ventilation slots, gratings and filters
are free of dirt and that they are not blocked. If required, clean the appliance and the
accessories according to the “CLEANING AND MAINTENANCE” chapter.
Connect the appliance mains plug to the electrical socket.
To switch on, press the On/Off switch.
The power-on lamp shows that the device is operating.
To switch off the device, press the On/Off switch.
Cooling Mode
After the machine turns on, press “MODE” to select cooling mode, cooling mode
indicator turns on.
Press “UP” or “DOWN” to adjust the temperature (from 16℃ to 32℃).
Press “SPEED” to select high or low fan speed.
To control the direction of the airflow horizontally, please adjust the inner louvre by
hand.
Note： The air conditioner stops if the room temperature is lower than the selected
temperature.
Fan mode
Press “MODE” to select fan mode, the fan mode indicator turns on.
Press “SPEED” to select high speed or low speed.
Temperature and sleep function cannot be set up in fan mode.
Note: In fan mode, the room air is circulated, but not cooled
To Next Page
Loading...
