AFTER SALES SUPPORT
Email: service@prolinkbrands.co.nz
Phone: 0508 776 546 - Mon-Fri 8:30am – 4.30pm Page 14
Dehumidifying mode
Press “MODE” to select dehumidifying mode, DEHUMIDIFY mode indicator turns
on.
In dehumidifying mode, the sleeping function cannot be used, and the fan speed
is low.
Note: The user should connect the hose to the drain outlet at the bottom of the unit
when using this mode.
Sleep mode （this function can only be used with a remote control）
The sleep mode can be activated when in cooling mode.
In cooling mode :
> After 1 hour the pre-set temperature is increased by 1 ℃, after another
hour the pre-set temperature will again be increased by 1 ℃.
The temperature is kept constant for 10 hours. And all the indicators dim to dark. The
fan speed will switch over to low speed for silent operation and cannot be changed.
Timer mode
The timer has two ways of operation:
To turn ON:
> In standby mode, press “TIMER” to set up the power-on time.
> Press “UP” or “DOWN” repeatedly to set the delay ON time.
> The timer indicator turns on.
To Turn OFF
> When the unit is turned on, press “TIMER” to set up the power-off timer.
> Press “UP” or “DOWN” repeatedly to set the delay OFF time.
> The timer indicator turns on.
To Cancel:
> Press Timer
> Press “UP” or “DOWN” repeatedly until the LED shows ‘00’.
Note: Pressing POWER will also exit the timer setting.
Compressor protection
To protect the life of the compressor there will be a three minutes delay after power
on / restart, for the compressor to run.
Frost Protection Function
At low room temperatures, frost may build up at the evaporator during operation. The
unit will automatically start defrosting and the POWER LED will blink. The defrost
control sequence is as follows:
To Next Page
Loading...
