AFTER SALES SUPPORT
Email: service@prolinkbrands.co.nz
Phone: 0508 776 546 - Mon-Fri 8:30am – 4.30pm Page 15
When the unit operates in the cooling function or drying operation, the ambient
temperature sensor senses the evaporator coil temperature.
If it is below -1°C, the compressor will stop operating for 10 minutes
Once it is up to 7℃, the unit restarts in cool operating mode.
Overflow Protection Function
When the water in the water pan exceeds the warning level, the machine will
automatically sound an alarm, and the "FULL" indicator light will flash. At this point,
you need to empty the water from the unit (refer to Drainage Instructions of this
chapter). After the water is emptied, the machine will automatically return to the
working state.
Drainage Instructions
Self- evaporating system
The self-evaporating system uses the collected water to cool the condenser coils for
better, more efficient performance. There is no need to empty the drainage tank in the
cooling operation, only in dehumidifying operation and high humidity conditions. The
condensed water evaporates at the condenser and is evacuated through the exhaust
hose.
Manual Drainage
This unit will stop if the internal water collection bowl is full. If this happens follow the
below for manual drainage.
1. Turn off the unit and unplug the power cord from the
supply.
2. Move the unit carefully so as not to spill the water in
the water pan. NOTE: this may require two people.
3. Find a place to drain the water or place a bucket
below the water outlet on the back of the unit.
4. Unplug the rubber plug and allow it to drain. During
draining the body can be tilted back slightly.
5. When the water is emptied the rubber plug can be re-
inserted securely.
Allow to sit for at least 5 minutes before turning back on.
To Next Page
Loading...
