AFTER SALES SUPPORT
Email: service@prolinkbrands.co.nz
Phone: 0508 776 546 - Mon-Fri 8:30am – 4.30pm Page 16
Continuous drain hose
(Inner diameter=16mm)
Continuous Drainage
For continuous operation or unattended operating in dehumidifier mode, please
connect a hose to the unit at the bottom drainage plug. NOTE: to operate permanent
drainage you need to allow the water to drain outside via gravity.
When the appliance is in cooling or dehumidifying mode, the continuous drainage
house needs to be inserted into the bottom drain hole.
1. Turn off the unit and unplug the power cord from the supply.
2. Remove the plug of the water outlet opening.
3. Securely connect the drain hose and make sure it is
not kinked and clear of obstruction.
4. Place the outlet of the hose over a drain or bucket
and ensure that water could freely flow out of the unit.
5. Do not submerge the end of the hose into the
water; otherwise, it can cause an "Air Lock" in the
hose.
6. As the condensate drain pan has negative pressure,
tilt the drain hose down toward the floor. It is appropriate that the degree of
inclination should exceed 20 degrees.
To Next Page
Loading...
