AFTER SALES SUPPORT
Email: service@prolinkasia.com
Phone: 0508 776 546 - Mon-Fri 8:30am – 4.30pm Page 15
1. Remove the filter frame and take off the filter.
2. Use a vacuum cleaner to gently vacuum the dust on the surface.
If the filter is very dirty, wash it with water and a soft detergent and dry it
thoroughly afterwards.
3. Replace the filter by reversing the above instructions.
NOTE: Never use rough scouring pads or abrasive cleansers on any plastic or metal
parts as the surface may be damaged.
Storing the Dehumidifier
When not in use store your appliance and all its accessories and instruction manual in
a safe and dry place.
1. Empty any water left in the drainage tank.
2. Fold up the power supply cord and put it in the water tank.
3. Clean the air filter.
4. Store in a cool and dry place.
NOTE: The unit must be kept in an upright position when in storage.
NOTE: The evaporator inside the machine has to be dried out before the unit is packed
to avoid component damage and mould. Unplug the unit and place it in a dry open
area for a few days to dry it out. Another way to dry the unit is to set the humidity
point more than 5% higher than the ambient humidity to force the fan to dry the
evaporator for a couple of hours.
To Next Page
