AFTER SALES SUPPORT
Email: service@prolinkasia.com
Phone: 0508 776 546 - Mon-Fri 8:30am – 4.30pm Page 14
Securely connect the drain hose and make sure it is not kinked and free of
obstruction.
Place the outlet of the hose over a drain or bucket and ensure that water could
freely flow out of the unit.
Do not submerge the end of the hose into water; otherwise, it can cause an
airlock in the hose.
As the negative pressure of the condensate drain pan is large, tilt the drain hose
down toward the floor. The degree of inclination should not be less than 20
degrees.
Straighten the hose to avoid a trap existing in the hose.
FUNCTIONING TEMP
5°C ≤ Ambient Temp. ≤ 35°C
When the ambient temp is lower or higher than the functioning temperature, the
dehumidifier will stop working.
When 5°C ≤ Ambient temp. ≤ 16°C, the compressor will automatically defrost at
intervals; during defrosting, the compressor stops and the fan keeps running.
CLEANING and MAINTENANCE
This appliance requires little maintenance. It contains no user-serviceable parts. Any
servicing requiring disassembly other than cleaning must be performed by a qualified
appliance repair technician.
Before Cleaning
Before unplugging the unit ensure all controls are set off.
When not in use or before cleaning, always disconnect the appliance from the
mains supply.
Care and Cleaning
Accumulated dust may be removed from dehumidifier surfaces with a soft cloth.
For more thorough cleaning, use a cloth that has been moistened with a solution
of mild detergent and water.
Dry the dehumidifier casing thoroughly with a soft, dry cloth before operating the
unit again.
To Clean the Air Filter
Dust collects on the filter and restricts the airflow. The restricted airflow reduces the
efficiency of the system and if it becomes blocked it can cause damage to the unit.
The air filter requires regular cleaning. The air filter is removable for easy cleaning. Do
not operate the unit without an air filter, or the evaporator may be contaminated.
To Next Page
Loading...
