AFTER SALES SUPPORT
Email: service@prolinkasia.com
Phone: 0508 776 546 - Mon-Fri 8:30am – 4.30pm Page 13
EMPTYING THE WATER TANK
The built-in water tank will fill up and shut the unit down once it is full. It will run again
once you empty the water tank and is installed correctly.
When the tank is full, The unit will make a buzzing sound, and the “Water Full”
light will turn on.
1. Press the POWER button to turn off the unit. Pull out the water tank by sliding out
of the body of the dehumidifier.
2. Empty the water into an area with a drain or outside.
3. Clean the inside of the tank as well as the outside with a damp cloth.
4. Replace the empty tank into the unit.
5. Press the POWER button to resume operation.
6. If the Water Full light does not turn off, check that the float on the water tank is
correctly in place.
CONTINUOUS DRAINING
For continuous operation or unattended dehumidification, please connect the attached
drain hose to the unit. Condensate water can automatically flow into a bucket or a
drain using gravity.
Set the unit in a horizontal surface and stable position.
Switch off the unit before operating.
Remove the plug of the water outlet opening, and keep it in a safe area.
To Next Page
Loading...
